Filter
Top Products
23
IMPORTANT: If the bearings need replacement,
this should be done by qualified service
personnel. The bearings are press fitted and
must be removed with an arbor press.
To re-install cutterhead, reverse the above
procedure. Before re-installing, make sure the
machine's curved seats of the base casting are
free of dirt, dust or grease, to help ensure a tight
fit.
NOTE: Whenever the cutterhead is re-installed
on the jointer, the tables must be leveled in
relationship to it.
You may wish to keep an extra cutterhead on
hand to maintain shop productivity.
Table Removal
1. Disconnect jointer from power source.
2. Remove fence assembly except for the
support casting.
3. Remove cutter guard.
4. Lower infeed and outfeed tables and remove
cutterhead.
5. Loosen the gib set screws and table lock
screws.
After gib screws are
loosened, table could suddenly slide down.
6. Remove infeed or outfeed table by sliding
upward.