Filter
Top Products
15
Mounting Table Insert
1. Place the table insert into the table opening.
With a straight edge, check to see if the
insert is level with the surface of the table.
See Figure 22.
2. If the insert is not level, correct it by using
the straight edge and turning the four set
screws in or out until the insert is flush with
the table.
Mounting Extension Wings
TIP: Use WD-40® to clean table edges.
1. Have an assistant hold the wing in place
while the three 7/16-14 x 1-1/4 screws are
inserted with the 7/16 lock washers. Do not
tighten screws completely.
(NOTE: If an assistant is not available, hold
the wing in vertical position and insert one
7/16-14 x 1-1/4 screw and one 7/16 lock
washer into the middle hole. See Figure 23.
Finger tighten this screw to the saw's table,
then pivot the wing to horizontal position,
and install the other two screws finger tight.)
2. The front edge of extension wing is the most
critical and must be flush with the front edge
of saw table. If necessary, tap the edges of
the wing with a rubber mallet (or hammer
and block of wood) until the front edge of
wing lines up with edge of table.
3. Place a straight edge across both the
extension wing and table top. Level the
surface of the wing with the table top, then
tighten the middle screw.
4. Repeat step 4 at the front and back of the
extension wing. Tighten each screw as that
part of the wing comes flush with the table.
5. Repeat process for other extension wing.
Mounting Rails and Accu-Fence®
With the extension wings properly aligned, the
rail and fence assembly can now be mounted to
the saw. Consult the separate Accu-Fence
manual for instructions.
Optional Wood Extension Table
For instructions on mounting the accessory
wood extension table, or router table, consult
your Accu-Fence® manual.
Figure 22
Figure 23