Filter
Top Products
10
6. Place the base over the hole pattern. Align
the four holes of the base with the holes in
the mounting surface. Make sure the lock
handle is positioned in a convenient place
before tightening the base to the mounting
surface.
7. Insert four M10 screws (not provided)
through the holes of the base and into the
holes on the mounting surface. See Figure
2. Tighten screws securely.
8. The stand assembly can be oriented with
either of the columns in horizontal or vertical
position. It is recommended, however, that
the longer lead screw be placed in the
horizontal position, as shown in Figure 3;
this will allow maximum adjustment for the
stock feeder across the surface of the
workpiece. Slide the vertical column down
into the base and tighten the lock handle
(Figure 3).
9. Attach a handle (Figure 4) to each elevating
handle, by screwing the threads of the
handle into the hole on the elevating handle.
10. The handle (Figure 4) should be adjusted so
that it can move freely. Loosen the hex nut
with a 14mm (9/16”) wrench, and turn the
socket head cap screw with a 5mm hex
wrench until the handle is just loose enough
to turn freely. Then tighten the hex nut
against the elevating handle.
11. Rest the Stock Feeder on the mounting
surface, as shown in Figure 5. Lower the
horizontal arm by rotating the top hand
wheel until the arm is at a convenient height
for mounting the Stock Feeder. (See “Basic
Feeder/Stand Movements” for detailed
explanation of stand movements.)
12. Make sure the hex cap screw (A, Figure 5)
is loosened on the sleeve of the Stock
Feeder. Use a 14mm wrench.
13. Slide the arm cone of the Stock Feeder onto
the horizontal arm as far as it will go, then
tighten the hex cap screw (A, Figure 5).
Figure 2
Figure 3
Figure 4
Figure 5