Filter
Top Products
6
Setting the Temperature
To reattach the stand
, simply place the
large tab on the side of the stand in the
notch on the side of the station and
slide the stand down until it clicks into
place.
5'66+0)"6*'"
6'/2'4#674'
Set the temperature before soldering
materials.
±
±±
±
1. Plug the station into an AC outlet.
2. Set
–/O
to
–
to turn on the station.
)+&–<
)+&–<)+&–<
)+&–<
(or
(&&–9
(&&–9(&&–9
(&&–9
) and
I;J
I;JI;J
I;J
appear on
the display, the red ON indicator
lights, and the station beeps.
3. Press
TEMPERATURE–
H
or
TEMPERATURE–
G
to set the
soldering tip’s temperature.
The soldering tip’s temperature
increases by 1
°
F (or 1
°
C) each
time you press
TEMPERATURE–
H
,
and decreases by 1
°
F (or 1
°
C)
each time you press
TEMPERATURE–
G
.
For faster setting, hold down either
TEMPERATURE–
H
or
TEMPERATURE–
G
until you reach
the desired temperature.
±
"016'"
±
"
• The soldering station
has two modes:
setting and reading.
Press
MODE
to
toggle between
modes.
I;J
I;JI;J
I;J
appears
on the right of the
display when the
soldering station is in
setting mode.
H;7:
H;7:H;7:
H;7:
appears on the right
of the display when
the soldering station
is in reading mode.
• The station has a two-
minute preset
memory function. If
you turn off the
station and turn it on
again within two
minutes, the preset
temperature remains
unchanged. The
temperature is reset
after two minutes.
• Clean the blue paint
off the tip before
using the station.
64-2185rc.fm Page 6 Monday, August 26, 2002 8:28 AM