Filter
Top Products
44
Pairing
All FLX2 wireless components are paired before the system is shipped, providing much
of the system setup already completed. While pairing should not be required for the
system to work, sometimes components can require pairing if a part is shipped
separately.
The following are instructions on how to pair the wireless components of the system to
the FLX2 Conference Phone. All components are paired to the Base, which is the
central unit that communicates with all other components. To pair a Microphone or a
Speaker to the FLX Conference Phone, a FLX Dialer has to be paired first. If several
components need to be paired, or a whole system needs to be paired, start with the
FLX Dialer.
Dialer
1. Turn off the Dialer by pressing and holding the red „end call‟ button until an
overlay appears asking whether you want to shut the Dialer down. Press „Yes‟.
2. Plug in the FLX2 Base Station.
3. Turn the Dialer back on (press the red „end call‟ key). The screen should read
“Scanning for new base”. If the screen reads “scanning for paired base”, press
the „Stop‟ button, press the „Menu‟, and select „Re-Pair‟. When asked whether to
„Scan for New Base‟, select „Yes‟.
4. After some time scanning for available bases, an overlay will appear asking „Pair
with <System Name>?‟ The system name is either the Factory preset name of
Flx_xxxxxx, with xxxxxx the last 6 digits of the BT number on the bottom of the
Base station, or the system name you previously selected in the Advanced
Setup. Select „Yes‟.
5. An overlay, ‟Pairing with base <System Name>‟, should appear followed by a
„Connecting…‟ and then and „Initializing…‟ screen. Shortly after that the Dialer
home screen will appear. Your Dialer is now paired.
6. If the Dialer does not automatically pair, repeat steps 1-5. If this still does not
resolve the problem, select “Reset Factory Defaults” as this will force a scan for a
new base.
Speaker
1. To pair a Speaker first turn it off by pressing and
holding the button on the bottom of the Speaker until
you hear the Speaker shut-off or the LEDs turn off.
2. Ensure that the Base Station is plugged in and powered
up.
3. On the Dialer, browse to the Pairing menu: Menu
Setup Advanced Setup Pairing.
4. Select SPK 1 (Speaker 1) and press the „Enter‟ or „Pair‟
key to enter pairing state.
5. The screen will display „Pairing Speaker 1‟.
6. Press and hold the button on the bottom of the Speaker
until the LED turns solid red. The speaker is now in
pairing mode.