Filter
Top Products
46
Phone Settings
1. Browse to the Phone Settings menu: Menu
Setup Advanced Setup Phone Settings.
a. You can change the dialing method by
selecting the entry, and then pressing the
„Select‟ key. The factory preset is TONE.
b. You can set the telephone number of the
FLX2 System using the Phone Number
setting. Select this entry, type in the
number, and press „Enter‟ to capture the
telephone number.
c. Selecting Hook Flash Time you can change
the time for a hook flash to be sent to your
network. Factory default is 75 ms, you can
increase this by selecting another entry in
the menu.
d. Disconnect ON/OFF allows you to ignore
signals sent by the far side indicating a
hang-up. If you are seeing „Line in Use‟
messages on your phone even though the
line is not in use, this setting has to be set
to OFF.
Power On/Off the System Components
During normal use and operation of the FLX2 System, there is no need to turn off any
part of the system. However, if the system is going to be stored without the Charger
Base powered on, then each component should be powered off until further use.
Dialer On/Off
To power off the FLX Dialer, hold down the red „end call‟ soft key until the device asks
whether you want to shut it down. Confirm this by pressing „Yes‟.
To turn the Dialer back on, either:
1. Hold down the red „end call‟ soft key until the Dialer powers on. OR
2. Simply return the Dialer to an active Charger Base and it will power on
automatically.
Speaker On/Off
To power off the FLX Speaker, hold down the button located on the bottom of the
Speaker until the LED indicators on the top of the Speaker turn solid red. Once the LED
indicators are solid red, release the button and the Speaker will power off.
To power the Speaker back on, either: