Filter
Top Products
1. When not in use, compressor should be
stored in a cool dry place.
2. Tank should be drained of moisture.
3. Hose should be disconnected and hung
open ends down to allow any moisture
to drain.
15
To change a filter, remove the pump/ motor shroud to expose pump. If filter is dirty,
replace.
Filter Removal, Inspection and Replacement
Lubrication
Storage
Operation Daily Weekly Every 3 Months
Check Oil Level ●
Drain Tank ●
Check Air Filter ●
Check Safety Valve ●
Blow Dirt From Inside Motor ●
Change Oil ●
Maintenance Schedule
Oil fill
hole
Drain
Plug
Before plugging in compressor, make sure
the crankcase is filled with 250ml/ 8.4 oz. of
ISO 100 (SAE 30), non-detergent
compressor oil, or Mobil 1 5W30 synthetic.
Use dipstick to check oil-level.
To Drain and replace the oil:
- Place a suitable container underneath
the drain to collect used oil.
- Remove oil drain plug with a 4mm hex
wrench.
- When the used oil has drained, reinstall
the drain plug and tighten using the 4mm
hex wrench.
- Remove the dipstick
- Add 250ml/ 8.4 oz. of ISO 100 (SAE 30),
non-detergent compressor oil, or Mobil 1
5W30 synthetic.
NOTE: Avoid overfilling with oil. Make sure
to check that the oil level is not above MAX
line on the dipstick.
- Re-insert the dipstick.