Filter
Top Products
15
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully lift saw from the carton by the carrying handle
and the saw base, and place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
This saw has been shipped with the saw arm secured in
the down position. To release the saw arm, push down
on the top of the saw arm, cut the tie-wrap, and pull out
on the depth guide.
Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the tie wrap and/or depth guide.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures ex-
plained in this manual.
If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing, do not oper-
ate this tool until the missing parts are replaced.
Failure to heed this warning could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in acciden-
tal starting and possible serious personal injury.
WARNING:
Do not start the miter saw without checking for
interference between the saw blade and the sliding
miter fences. Damage could result to the blade if
it strikes the miter fence during operation of the
saw.
WARNING:
Always make sure the compound miter saw is
securely mounted to a workbench or an approved
workstand. Failure to heed this warning can result
in serious personal injury.
MOUNTING HOLES
See Figure 8.
The compound miter saw should be mounted to a firm
supporting surface such as a workbench, mounting board,
or leg stand. The saw base has eight mounting holes: four
large bolt holes (B) and four small screw holes (A). If using
bolts, they should be of sufficient length to accommodate
the saw base, lock washers, hex nuts, and the thickness of
the workbench or other mounting surface. Tighten all four
bolts or screws securely. Do not use screws if mounting to
a leg stand.
The hole pattern for mounting to a workbench is shown in
figure 8. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
TRACE HOLES AT THESE
LOCATIONS FOR HOLE PATTERN
(A - SCREWS AND B - BOLTS)
SAW BASE
Fig. 8
MOUNTING
SURFACE
A B
A
A
AB
B
B