Page 10
Fig. 3
The following tools (not included) are needed for checking adjustments of your saw or for installing the blade:
Combination Square
Phillips Screwdriver
TOOLS NEEDED
PHILLIPS SCREWDRIVER
COMBINATION
SQUARE
Check all loose parts from the box with the list below. Assemble according to the instructions on the following pages.
LOOSE PARTS LIST
MITER GAUGE
4 mm HEX KEY
SAW TABLE
Fig. 4
FLAT HEAD SCREW
TABLE ALIGNING
BOLT
WASHER
WING NUT
RIP FENCE
WING SCREW
WORKLIGHT
Hex Key, 4 mm ................................................................ 1
Rip Fence......................................................................... 1
Miter Gauge ..................................................................... 1
Saw Table ........................................................................ 1
Wing Screw ...................................................................... 1
Wing Nut .......................................................................... 1
Table Aligning Bolt ........................................................... 1
Flat Head Screw .............................................................. 3
Worklight .......................................................................... 1
Washer............................................................................. 1
Switch Key ....................................................................... 1
Operator’s Manual (not shown) ....................................... 1
SWITCH
KEY