Filter
Top Products
Page 20
OPERATION
FEATHERBOARD
A featherboard is a device used to help control the workpiece
by guiding it securely against the table or fence. Featherboards
are especially useful when ripping small workpieces and for
completing non-through cuts. The end is angled, with a
number of short kerfs to give a friction hold on the workpiece.
Lock it in place on the table with a C-clamp. Test that it could
resist kickback.
WARNING:
Place the featherboard against the uncut portion of the
workpiece, to avoid kickback that could cause serious
personal injury.
HOW TO MAKE A FEATHERBOARD
See Figure 19.
The featherboard is an excellent project for your BTS15.
Select a solid piece of lumber approximately 3/4 in. thick, 3-5/8 in.
wide and 18 in. long. Mark the center of the width on one end
of the stock. Miter one-half of the width to 30° and miter the
other half of the same end to 45°. See page 24 for information
on miter cuts. Mark the board from the point at 6 in., 8 in., 10
in. and 12 in. Drill a 3/8 in. hole at the 8 in., 10 in., and 12 in.
marks. Set the rip fence to allow approximately a 1/4 in.
"finger" to be cut in the stock. Feed the stock only to the mark
previously made at 6 in. Turn the saw OFF and allow the
blade to completely stop rotating before removing the stock.
Reset the rip fence and cut spaced rips into the workpiece to
allow approximately 1/4 in. fingers and 1/8 in. spaces between
the fingers.
HOW TO MOUNT A FEATHERBOARD
Remove the adjusting clamp knob, bolt and washer from the
Miter Fence Holder. Place the bolt through one of the holes
in the featherboard. Positioning the featherboard will depend
on the placement of the bolt. Place the washer on the bolt and
attach the adjusting clamp knob, loosely. Position the
featherboard with the hex head of the bolt in the miter table
slot but do not tighten. Completely lower the saw blade.
Position the rip fence to the desired adjustment for the cut to
be performed and lock. Place the workpiece against the
fence and over the saw blade area. Adjust the featherboard
to apply resistance to the workpiece just forward of the blade.
Securely tighten the adjusting clamp knob to secure the
featherboard in place. Attach a C-clamp to further secure the
featherboard to the edge of the sliding miter table.
WARNING:
DO NOT locate the featherboard to the rear of the
workpiece. Kickback can result from the featherboard
pinching the workpiece and binding the blade in the saw
kerf if positioned improperly. Failure to heed this warning
can result in serious personal injury.
Fig. 18
Fig. 19
3/8 in. DIAMETER
1/8 in.
1/4 in.
3/4 in.
3-5/8 in.
1-13/16 in.
30°
45°
6 in.
8 in.
10 in.
12 in.
18 in.
PUSH BLOCK
“C” CLAMP
FEATHERBOARD
PUSH STICK
BEVEL
LOCKING
LEVER