Ryobi SC163VS Saw User Manual


 
Page 13
ADJUSTMENTS
INSTALLING BLADES
Scroll saw blades wear out quickly and must be replaced
frequently for best cutting results. Expect to break some
blades while you learn to use and adjust your saw. Blades
generally stay sharp for 1/2 hour to 2 hours of cutting,
depending on the type of material and speed of operation.
Pin End Blades
See Figure 10.
Removing the Saw Blade:
Turn off and unplug the saw from the power source.
WARNING:
Failure to turn the saw off, remove the switch key, and
unplug the saw from the power source could result in
accidental starting causing possible serious injury.
Turn blade tension knob counterclockwise to decrease
(or loosen) blade tension.
See Figure 4.
Pushing up from under the saw table, remove the throat
plate.
Using the T-handle hex key supplied with the saw, loosen
both the upper and lower blade clamp screws.
Pull up on the blade and push down on the saw arm to
disengage the upper pin in the V-notch of the upper blade
holder. Push the blade downward to disengage the lower
pin in the V-notch of the lower blade holder.
Remove the blade.
Replacing the Saw Blade:
Place the new blade through the opening in the saw table
with the teeth to the front of the saw and pointing down
toward the saw table. The pins on the blade go under the
blade holder in the V-notch of the lower blade holder.
Pull up on the blade and press the upper arm down to
position the upper end of the blade in the V-notch in the
upper blade holder.
Securely tighten the upper and lower blade clamps using
the T-handle hex key supplied with the saw.
Turn the blade tension knob clockwise until the blade has
the desired amount of tension.
Replace the throat plate.
Note: If the blade touches the drop foot on either side then
the drop foot must be adjusted. See section on Adjusting
Drop Foot, page 12.
Plain End Blades
See Figure 10.
Turn off and unplug the saw from the power source.
WARNING:
Failure to turn the saw off, remove the switch key, and
unplug the saw from the power source could result in
accidental starting causing possible serious injury.
Removing the Saw Blade:
Turn blade tension knob counterclockwise to decrease
(or loosen) blade tension.
See Figure 4.
Pushing up from under the saw table, remove the throat
plate.
Using the T-handle hex key supplied with the saw, loosen
both the upper and lower blade clamp screws.
Remove the blade.
Replacing the Saw Blade:
Place the new blade through the opening in the saw table
with the teeth to the front of the saw and pointing down
toward the saw table. Place the lower end of the blade in
the V-notch in the lower blade holder.
Position blade and tighten the blade clamp screw se-
curely using the T-handle hex key.
Pull up on the blade and press the upper arm down to
position the upper end of the blade in the V-notch in the
upper blade holder.
Securely tighten the upper blade clamp screw using the
T-handle hex key.
Turn the blade tension knob clockwise until the blade has
the desired amount of tension.
Replace the throat plate.
Note: If the blade touches the drop foot on either side then
the drop foot must be adjusted. See section Adjusting Drop
Foot, page 12.
Fig. 10
T-HANDLE
HEX KEY
DROP FOOT
LOCK KNOB
BLADE
CLAMP
SCREW
SAW BLADE
BLADE CLAMP
SCREW
THROAT
PLATE
SAW
BLADE