Filter
Top Products
22
ADJUSTMENTS
Fig. 24
LOCK NUT
BEVEL
LOCK
KNOB
PIVOT POINTS
The following adjustments are made at the factory and
normally do not require readjustment.
TRAVEL PIVOT
The saw arm should rise completely to the up position by
itself. If the saw arm does not raise by itself or if there is
play in the pivot joints, have saw repaired by a qualified
service technician to avoid risk of personal injury.
BEVEL PIVOT
The compound miter saw should bevel easily by loosening
the bevel lock knob and tilting the saw arm to the left. If
movement is tight or if there is play in the pivot, have saw
repaired by a qualified service technician.
DEPTH STOP
The depth stop limits the blade's downward travel. It
allows the blade to go below the miter table enough to
maintain full cutting capacities. The depth stop positions
the blade 1/4 in. (6.4 mm) from the miter table support.
NOTE: The miter table support is located inside the miter
table.
The depth stop is factory set to provide maximum cutting
capacity for the 12 in. (305 mm) saw blade provided with
the saw. Therefore, the depth stop should not need an
adjustment for the saw blade provided.
WARNING:
If any part fails to function properly, do not operate
this tool until you have it repaired by a qualified
service technician. Failure to heed this warning can
result in serious personal injury.