Filter
Top Products
7
UNPACKING
INFORMATION
We have shipped the miter saw completely assembled
except for the blade, miter lock handle, dust guide/dust
bag, table extensions, and stop block.
■ Remove the loose parts from the box. Make sure
that all items listed in the loose parts list are in-
cluded.
■ Remove the packing materials from around the saw.
■ Lift the saw carefully from the box and place it on a
level work surface.
NOTE: The saw is heavy. Ask for assistance if
necessary.
■ Do not discard the packing material until you have
carefully inspected the tool, identified all loose parts,
and satisfactorily operated the tool.
■ The saw is shipped with the saw arm locked in the
down position. To release the saw arm, push down
on the top of the saw arm and pull out the lock pin.
Apply hand pressure on the saw arm to prevent
sudden rise upon release of the lock pin.
■ If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
■ Inspect all parts carefully to make sure no breakage
or damage occurred during shipping.
WARNING:
If any parts are missing do not operate the tool until
the missing parts are replaced. Failure to do so
could result in serious personal injury.
NOTE: The compound miter saw has been adjusted at
the factory for making very accurate cuts. However,
some of the components might have been jarred out of
alignment during shipping. Also, over a period of time,
readjustment will probably become necessary due to
wear. After unpacking your saw, check the saw
adjustments before you begin using the saw. Make any
readjustments that are necessary and periodically check
the parts alignment to make sure that the saw is cutting
accurately. Refer to ADJUSTMENTS later in this manual.
LOOSE PARTS LIST
1. Saw blade
2. Miter lock handle
3. Dust bag
4. Dust guide
5. Stop block
6. Small wing screw
7. Clamp brackets (2)
8. Clamp bracket screws (2)
9. Table extensions (2)
10. Work clamp
11. Hex blade wrench
1
2
3
4
5
6
7
8
9
10
11