Filter
Top Products
i
bas c operation
BEVEL SANDING
The worktable can be tilted from 0oto 45° for bevel
sanding. Loosen the table lock knob and tiltthe work-
table to desired angle as shown. Retighten table lock
Knob.
TABLE
WARNING: TO avoid trapping the work or fingers
between the table and sanding surface, the table
should be reposltioned on the table support to retain
a maximum of 1/16 Inch distance between sanding
surface and table.
POSITIONING BELT BED
A bed lockinghex socket head screw locks the belt bed
in a vertical or horizontal position.
To adjust vertical position:
1. Remove the work support.
2. Loosen the hex socket head locking screw using a
6mm hex wrench.
,WORK SUPPORT
HEX SOCKET
SCREW
_HEX"L" WRENCH
3. Position belt bed vertically as shown and tighten the
hex socket head screw.
16