Filter
Top Products
contents
POWER TOOL WARRANTY ......................... 2
SAFETY INSTRUCTIONS FOR
BELT D)SC SANDEF ............................................. 2
MOTOR SPECIFICATIONS AND
ELECTRICAL REQUIREMENTS ........................... 5
UNPACKING AND CHECKING CONTENTS ............ 6
ASSEMBLY ................................................................ 7
Mounting Belt and Disc Sander
to Workbench .................................................... 7
Clamping Belt and Disc Sander
to Workbench .................................................... 7
Installing Sanding Disc and Guard ........................ 8
Installing Backstop ................................................. 8
Installing Table Assembly ...................................... 8
Auxilliary Mounting for Vertical Sanding .............. 10
Squaring Table Assembly .................................... 10
Installing the Sanding Belt - Tensioning
and Tracking .................................................... 10
GETTING TO KNOW YOUR
BELT AND DISC SANDER .................................. 12
On-Off Switch ....................................................... 13
BASIC OPERATION ............................................ 14
Bevel Sanding ...................................................... 16
Positioning Belt Table .......................................... 16
Surface Sanding on Sanding Belt ........................ 17
End Sanding on the Sanding Belt ........................ 17
Sanding Curved Edges ........................................ 17
Sanding Small End Surfaces ............................... 18
MAINTENANCE ....................................................... 19
Lubrication .......................................................... 19
Removing Pulley Cover and
Installing Timing Belt ............................... 19
Installing Pulley Cover ......................................... 20
TROUBLESHOOTING ............................................ 21
RECOMMENDED ACCESSORIES ........................ 21
REPAIR PARTS ....................................................... 22
unpacking and checking contents
TOOLS NEEDED
_OMMWRENCH
COMBINATION SQUARE
PHILLIPS TYPE
SCREWDRIVER
6M_ HE;( "L"WRENCH
STANDARD
SCREWDRIVER
COMBINATION SQUARE MUST BE TRUE
STRAIGHT EDGE OF BOAR_
3/4" THICK. THIS EDGE MUST
DRAW LIGHT LfNE ON 8E pERFECTLY STRAIGHT.
BOARD ALONG THIS EDGE _
f
SHOULD BE NO GAP OR (3VERLAP
HERE WHEN SQUARE IS FLIPPED
OVER IN DOT'(lED POSITION,
H
Model 113.22643 Belt and Disc Sander is shipped
complete in one carton.
Separate all parts from packing materials and check
each item with illustration and 'qable of Loose Parts."
NOTE: Make certain all items are accounted for, before
discarding any packing material.
WARNING: To avoid injury, ifany parts are missing,
do notattempt to assemblethe Belt and Disc Sander,
plug Inthe power cord, or turn the switch on untilthe
missing parts are obtained and installed correctly.
WARNING: Foryourownsafety, neverconnect plug
to power source outlet, or insert switch key until all
assembly steps are complete and until you have
read and understood the entire owners manual,
ITEM TABLE OF LOOSE PARTS
I
A Belt and Disc Sander Assembly
B Owner's Manual
C Table
D Sanding Disc
E Table Support
F Guard Disc
G Work Support
H Bag Assembly
Containing the following parts:
Knob
Washer, 6.5 x 17.8 x 1.6
Screw, Pan Hd. TY "AB"
M4.2 x 1.9-12
Switch Key
Lockwasher, Ext. M6
Scale Label
Screw, Hex Hd. M6 x 1.0-14
Hex "L" Wrench 6mm
QTY.
1
1
1
1
1
1
1
2
1
4
1
4
1
6