Filter
Top Products
TRANSAXLE COOLING
The fan and cooling fins of transmission should be kept
clean to assure proper cooling.
Do not attempt to clean fan or transmission while engine is
running or while the transmission is hot. To prevent
possible damage to seals, no not use high pressure water
or steam to clean transaxle.
o inspect cooling fan to be sure fan blades are intactand
clean.
° Inspect cooling fins for dirt, grass clippings and other
materials. To prevent damage to seals, do not use
compressed air or high pressure sprayer°
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fluid mainte-
nance is not required for the life of the transaxle. Should
the transaxle ever leak or require servicing, contact your
nearest authorized service center/departmento
V-BELTS
Check V_belts for deterioration and wear after 100 hours of
operation and replace if necessary° The belts are not
adjustable_ Replace belts if they begin to slip from wear.
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service
classificationSForSG_ Selectthe oil sSAEviscositygrade
according to your expected operatingtemperature.
SAE VISCOSITY GRADES
_F -20* 0 = 30 _ _?o 40 = 60o 80_ 100,
% -so'...... -2o° -lo". . o° 1o° .....20, ..3o".. 40°
TEMPERATURE RANGE ANT_CIPATED BEFORE NEXT OiL CHANGE
FIG. 14
NOTE: Although multi-viscosity oils (5W30, ! 0W30, etc.)
improves starting in cold weather, these multi-viscosity oils
will result in increased oil consumption when used above
32"C. Check your engine oil level more frequently to avoid
possible engine damage from running low on oil
Change the oil after the first two hours of operation and
every 50 hours thereafter or at least once a year if the
tractor is not used for 50 hours in one year°
Check the crankcase oil level before starting the engine
and after each eight (8) hours of continuous use_
BILITJES
TO CHANGE ENGINE OIL (See Figs. '14 and 15)
Determine temperature range expected before oil change.
All oil must meet API service classification SF or SGo
° Be sure tractor is on level surface,,
. Oi! will drain more freely when warm,,
• Catch oil in a suitable container,,
• Remove oil fill cap!dipsticko Be careful not to allow dirt
to enter the engine when changing oil
° Remove drain plugo
• After oil has drained completely, replace oil drain plug
and tighten securely.
= Refill engine with oil through oil fill dipstick tube. Pour
slowly. Do not overfill° For approximate capacity see
"PRODUCT SPECIFICATIONS" on page 3 of this
manual.
° Use gauge on oil fill cap/dipstick for checking level. Be
sure dipstick is in all the way for accurate reading,
Keep oil at "FULL" line on dipstick,
AIRSCREEN OIL DRAIN PLUG
\
ENGINE OIL
FILL CAP/DIPSTICK
FIG. 15
CLEAN AIR SCREEN (See Fig. 15)
Air screen must be kept free of dirt and chaff to prevent
engine damage from overheating. Clean with a wire bnJsh
or compressed air to remove dirt and stubborn dried gum
fibers.
19