Filter
Top Products
RVICE A
DADJUSTME
TO REPLACE HEADLIGHT BULB
° Raise hood.
° Pull bulb holder out of the hole inthe backside of the
gdll,
° Replace bulb in holderand push bulb holder securely
back into the hole in the backside of the grill.
° Close hood,
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting,
° Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
ADJUSTMENT
•SPRING BUSHING
JAM NUT
o
ATTACHMENT
LIFT SPRING
°/
FIG. 32
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 32)
° While holdingspring bushingwithwrench, loosen jam
nut.
° Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier attachments°
• Turn adjustment bolt counterclockwise for lighter at-
tachments,
° Retighten jam nut against spring bushing.
IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER. ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 33)
* Raise hood,
° Unsnap headlight wire connector.
. Stand in front oftractor. Grasp hood at sides, tilt toward
engine arid lift off of tractor.
. To replace, reverse above procedures,
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 33
26