Filter
Top Products
-12-
D('(*Fne\ijDXelXcD]^%J`eZ\-&'0
J<KLG
N_\\cj#=\\k#Xe[
:XY`e\k
=`^li\+% Installing wheels and feet.
=`^li\,% Front and rear panels installed.
=`^li\-% Left panel installed.
This bandsaw is shipped with four rubber feet with posts
and two wheels with an axle. It is your option to install
four rubber feet if you do not need to move the bandsaw,
or install the axle and wheels if you need to move the
bandsaw regularly.
Kf`ejkXcck_\n_\\cj#]\\k#Xe[k_\ZXY`e\k#[fk_\j\
jk\gj1
(% At the end of the base with the axle holes, insert
the axle into the base (see =`^li\+).
)% Slide a 17mm flat washer and wheel onto each end
of the axle, followed by another 17mm flat washer
and cotter pin.
*% Thread a 3⁄8-16 hex nut on both rubber feet.
+% Thread rubber feet into the base (see =`^li\+).
,% Position the base on the floor, and adjust the feet
until the base is level and stable.
-% Tighten the hex nuts against the base to lock the
feet in position.
.% Position the front and rear panels on the base and
install the panels to the base with four M6-1 x 12
Phillips head screws and 6mm flat washers, as shown
in =`^li\,.
/% Position the left panel between the front and rear
panels, and secure it in place with six M6-1 x 12
Phillips head screws and 6mm flat washers, as shown
in =`^li\-.