Filter
Top Products
-15-
D('(*Fne\ijDXelXcD]^%J`eZ\-&'0
J<KLG
:_`gKiXp:Xjk@ife
Jkfg
The chip tray directs small workpieces into a bucket when
the cut is complete. The cast iron stop allows you to
repeat cuts at the same length.
Kf`ejkXcck_\Z_`gkiXpXe[ZXjk`ifejkfg#[fk_\j\
jk\gj1
(% Position the chip tray, as shown in =`^li\().
)% Insert the stop rod approximately
3
⁄4" into the saw
until the end of the rod is just flush with the inside
casting surface, as shown in =`^li\(*.
*% Use a 4mm hex wrench to tighten the set screw
shown in =`^li\(*.
+% Slide the cast iron stop onto the stop rod and tighten
the set screw in the side of the stop, as shown in
=`^li\(+.
=`^li\()% Chip tray installed.
Chip Tray
=`^li\(*% Installing stop rod.
Set Screw
=`^li\(+% Cast iron stop installed.
Set Screw