Filter
Top Products
-22-
D('(*Fne\ijDXelXcD]^%J`eZ\-&'0
FG<I8K@FEJ
,% Adjust the cast iron stop for duplicate cuts and
install the ejector chute if required.
-% Loosen the headstock lock lever (=`^li\)+), and
swivel the headstock to the needed angle of cut, and
lock the lever in place.
.% Set the blade guide so the guides hold the blade
close to the workpiece, and the blade will not
twist with a cutting load (refer to 9cX[\>l`[\j on
GX^\(0 for detailed instructions).
/% Open the feed ON/OFF valve and turn the feed
rate knob so the feed rate is correct, based on your
observations of the blade chip characteristics. Refer
to =\\[IXk\ on GX^\), for detailed instructions.
Note: When the cut is complete, the ON/OFF switch
push lever will shut F== the bandsaw.
=`^li\)+% Headstock swivel system.
Lock Lever