Woodstock W1669 Cordless Drill User Manual


  Open as PDF
of 44
 
-9-
Secure base to floor.
Securebaseto4'x4'x
3
⁄4" plywood.

 
 

 Position the drill press in a sensible work
area where the base sits flat at all four
corners, or the base may crack when you
tighten the fasteners.
 Mark and drill the floor, and install the
concreteanchorbolts(notincluded)(see
).
 Position the base and fasten the base to
the floor carefully as not to crack it.
  
  
 Center the drill press base along the back
edgeofthe4'x4'x
3
⁄4" sheet of plywood
(see).
Ateachcornerofthedrillpressbase,drill
the plywood.
 Secure the base to the plywood with four
3/8"diameterbolts,washers,andnuts
(notincluded).


 Position the base on a bench or tool table
capableofsupportingapproximately100
lbs.
Drilltwomountingholes(),and
secure the base to the table with the two
supplied carriage bolts and wing nuts
 Place the column on the base, and install the
four column bolts supplied.
Formaximumstability,securetheW1670
floor-model drill press to a sturdy surface like
afloorora4'x4'x
3
⁄4" piece of plywood. For
theW1669bench-model,secureittoasturdy
workbench or tool table.


   



Workbenchmountingholes.
Mounting
Holes

 previous next