Woodstock W1669 Cordless Drill User Manual


  Open as PDF
of 44
 
Use to select the optimum motor-to-spindle pulley ratio for drilling, cutting, and sanding
operations. for example the above figure shows the belt in the C position on the spindle pulley and the
#3positiononthemotorpulley,whichwillgiveaspeedof1,520RPM.Refertothe
 on  for suggested tool RPMs.
Drill Press RPM Chart.


Your new drill press comes fitted with a depth
stop that allows drilling many holes at a pre-
setdepthconsistently.Whenthehexnutsare
set, the nuts will contact the stop flange and
stop the drill press from drilling any deeper.

 Measure the maximum depth that you want
to drill a series of holes at. In this example
the maximum depth is 1
1
⁄4" deep.
 Loosenthehexnutsshownonthedepth
stop and align the lower nut to the 1
1
⁄4"
markonthedepthstoprod(see
).
 Hold the lower hex nut and tighten the
upper hex nut so both nuts are locked
together.
 Make sure the depth has been set cor-
rectly, measure, or drill a hole into scrap
wood before drilling into any workpiece.
Depth stop set for 1
1
⁄4" drilling
depth.


Upper
Hex Nut




"

-22-
 previous next