Woodstock W1669 Cordless Drill User Manual


 
-7-
 The electrical cord sup-
pliedwiththeW1669andW1670RadialDrill
Press comes with a grounding pin. 
remove the pin if your outlet does not accept a
ground pin, see . Have the outlet box
replaced by a qualified electrician or have an
appropriate adapter installed.
Remember, an adapter with a grounding wire
does not guarantee the machine will be ground-
ed.Agroundsourcemustalwaysbeverifiedin
the electrical circuit within the wall or conduit.



The SHOP FOX
®
W1669andW1670RadialDrill
Pressesoperateat110voltsonly.Themotor
supplied with your new drill press is rated at
1⁄2HPandwilldrawapproximately5amps.
Whenchoosinganoutletforthismachine,con-
sider using one with a 15 amp circuit breaker
orfuse.Keepinmindthatacircuitbeingused
by other machines or tools at the same time
will add to the electrical load being applied by
thedrillpress.Adduptheloadratingsofall
machines on the circuit. If this number exceeds
the rating of the circuit breaker or fuse, use a
different outlet.
 modify an existing low-amperage
circuit by only replacing the circuit breaker
with a breaker rated for a higher amperage.
The breaker and the complete circuit must be
replaced by a qualified electrician.
   
    
   
  


Never remove a grounding pin.
If you must use an extension cord, use the guide-
lines below to determine the correct cord length
andgauge.Ifyouuseanundersized-gaugeexten-
sion cord or one that is too long, heat will gener-
ate in the cord and fire or circuit damage may
result.






