Filter
Top Products
-8-
W1677/W1711 10" Table Saw
SAFETY
Specific Safety Instructions for Table Saws
1. Always use guard, splitter and anti-kickback pawls on all ''through-sawing'' operations. Through-
sawing operations are those when the blade cuts completely through the workpiece as in ripping or
crosscutting.
2. Always hold the work firmly against the miter gauge or the fence when cutting.
3. Always use a push-stick for ripping narrow stock.
4. Never perform any operation ''free-hand'' which means using only your hands to support or guide the
workpiece. Always use either the fence or the miter gauge to position and guide the work.
5. Never stand or have any part of your body in line with the path of the saw blade.
6. Never reach behind or over the blade with either hand for any reason.
7. Move the rip fence out of the way when crosscutting with the miter gauge.
8. Always use multiple light passes when cutting deep non-through cuts.
9. Never attempt to free a stalled saw blade without first turning the saw
OFF.
10. Provide adequate support to the rear and sides of the saw table for wide or long workpieces.
11. Avoid kickbacks. A condition in which a piece of wood is thrown back towards an operator at a high
rate of speed. Usually is caused by the stock becoming trapped between the stationary face of the
rip fence and the rotating side of the saw blade. Do not operate the machine until you know what
a kickback is and how to avoid it.
12. Avoid awkward operations and hand positions where a sudden slip could cause your hand to move
into the blade.
13. Avoid cutting warped stock or stock that may contain loose knots, nails or any other defects. These
conditions may cause kickback.
USE this and other machinery with caution
and respect. Always consider safety first,
as it applies to your individual working
conditions. No list of safety guidelines can
be complete—every shop environment is
different. Failure to follow guidelines could
result in serious personal injury, damage
to equipment or poor work results.
READ and understand this
entire instruction manual
before using this machine.
Serious personal injury
may occur if safety and
operational information is
not understood and fol-
lowed. DO NOT risk your
safety by not reading!