Filter
Top Products
ASSEMBLY
-12-
Figure 8. Mounting the casters to the base.
Base
Position the base upside down to reveal the
caster mounting brackets. Attach each of the (4)
casters to the caster mounting brackets using
(16)
5
/16"-18 x
1
/2" hex bolts as shown in Figure 8.
General
While the main components of the Shop Fox
®
Model W1687 are assembled at the factory,
some assembly is required. The following is the
recommended sequence best suited for final
assembly.
TOOLS REQUIRED: You will need a 12mm open
end wrench and a Phillips head screwdriver.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Make sure that your
machine remains
unplugged during any
assembly, adjustment or
maintenance procedures.
Ignoring this warning may
result in serious personal
injury!
Safety glasses must be
worn to prevent serious
personal injury!