Filter
Top Products
ASSEMBLY
-14-
Support Brackets
Each support bracket assembly consist of an
upper and a lower bracket. The lower brackets
bolt to the base and to the side of the collec-
tors. The upper brackets bolt to the side of the
collectors and extend upward. The upper brack-
ets have hooks that support the upper bags.
1. Attach each lower bracket to the top edge of
the base plate using (4)
5
⁄16"-18 x
1
⁄2" bolts as
shown in Figure 12.
2. Line up the two holes of each upper bracket
with the holes on each lower bracket, as
well as the holes on the collector sides.
Secure the upper and lower brackets to the
collectors with (4)
5
⁄16"-18 x
3
⁄4" bolts as
shown in Figure 13.
Collectors
The (2) collectors attach to each of the outlet
duct flanges and are later secured to the base
with the support bracket assemblies. The inside
of the collectors are cone shaped to force the
air around in a circular motion. Be sure that the
inside taper (cone) is pointing downward and
that the collector inlet flange faces the outlet
duct flange. Insert one of the rubber gaskets
between the outlet duct flange and the collec-
tor flange. Secure with (8)
5
⁄16"-18 x
1
⁄2" bolts as
shown in Figure 11. Repeat the procedure for
the other collector on the opposite side.
Figure 11. Attaching the collector
to outlet flange.
Figure 12. Mounting the brackets to the base.
Figure 13. Mounting the collector
to the brackets.