Filter
Top Products
-13-
Model W1706 (Mfg. Since 8/10)
SETUP
12. Place the fence assembly onto the front rail and
position it to the left of the table insert, then secure
it in place by pressing down on the lock lever (see
Figure 12).
Figure 12. Fence secured in place.
Lock Lever
DO NOT operate this machine without an adequate
dust collection system. This machine creates substan-
tial amounts of wood dust while operating. Failure to
use a dust collection system can result in short and
long-term respiratory illness.
Recommended CFM at Dust Port: ................ 400 CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the
dust port, you must take into account many variables,
including the CFM rating of the dust collector, the length
of hose between the dust collector and the machine, the
amount of branches or Y's, and the amount of other open
lines throughout the system. Explaining this calculation
is beyond the scope of this manual. If you are unsure of
your system, consult an expert or purchase a good dust
collection "how-to" book.
Dust Collection
To connect a dust collection hose, do these steps:
1. Slide a 4" dust hose over the dust port and secure it
in place with a hose clamp, as shown in Figure 13.
2. Tug on the hose to make sure it is secure.
Note: A tight fit is necessary for proper dust
collection.
Figure 13. Dust collection hose connected
to the dust port.