-13-
W1730 Oscillating Edge Sander
Open the belt access door by removing the star
knobs and opening all latches.
Lift the belt tensioning lever as shown in .
Determine the belt direction from the arrow on the
dust port and the access door.
Match the arrows on the sander to the arrows inside
the sanding belt, and place and center the belt on
the sanding drums as shown in .
Tension the sanding belt by pushing the belt
tensioning lever down.
Close the belt access door, insert the star knobs,
and latch the levers.
Adjust the belt tracking as described on.
Released position of the belt
tensioning lever.
Placing the sanding belt onto
the sanding drums.
Place a 5/16" flat washer on each 5/16-18 x 1 hex
bolt and thread them approximately one turn into
the holes in the platen shown in .
Slide the back stop onto the hex bolts and tighten,
allowing 1/8" clearance between the belt and the
edge of the back stop.
Backstop bolts threaded into
platen.
Belt Direction
Arrows