Filter
Top Products
-26-
W1730 Oscillating Edge Sander
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not covered
in this section, please contact Woodstock International
Technical Support for additional guidance at (360) 734-
3482 or send e-mail to: .
In order to maintain accuracy and precision with the oscil-
lating edge sander, periodically calibrate the angle gauge.
Loosen the angle adjustment lock handle.
Place the machinist's square on the table and press
it against the platen.
Adjust the platen until it is flush with the
machinist's square as in .
Tighten the angle adjustment lock handle.
Loosen the angle indicator pin screw, shown in
, a 1/2 turn.
Align the angle indicator pin with the 90˚ mark and
tighten the angle indicator pin screw.
Aligning table to platen.
Angle indicator pin screw.