-27-
W1730 Oscillating Edge Sander
The Model W1730 comes equipped with a puller to
remove the drive roller should it ever become necessary
to do so.
Remove the hex nut and lock washer securing the
driver roller to the shaft.
Thread the two 1/4-20 x 1-3/4 cap screws on the
puller four turns into the threaded holes in the drive
roller.
Thread and tighten the 5/16-18 x 1-1/4 cap screw
into the puller, shown in , until the drive
roller is pulled.
To re-install, place the drive roller on the shaft, and
thread the lock washer and hex nut onto the shaft
and tighten securely. Do not hammer the drive
roller onto the shaft or you will cause damage to the
shaft.
Using the drive roller puller.