Filter
Top Products
-24-
W1730 Oscillating Edge Sander
The spindle connector connects the shafts from the
motor to the gear box and is secured by two set screws
that need to be tightened every time the gear box oil is
filled (every 500 hours).
Refer to on to
remove the gear box cover
Tighten the set screws shown in .
Reinstall the gear box cover.
Spindle connector set screws.
The eccentric on the Model W1730 is connected to the
shaft by a set screw. This set screw needs to be tightened
every time the gear box oil is filled (every 500 hours).
Refer to on to
remove the gear box cover.
Tighten the set screw on the eccentric, shown in
.
Reinstall the gear box cover.
Eccentric set screw.