Filter
Top Products
13.
Assembly and adjustments
Mounting belt and disc sander to
workbench (Fig. 13)
I
f belt and disc sander is to be used in a permanent
location, it should be fastened securely to a firm
supporting surface such as a workbench.
I
f mounting to a workbench, holes should be drilled
through supporting surface of the workbench.
1.The unit should be bolted securely using M8
screws and hex nuts (not included). Screw length
should be 38mm plus the thickness of the bench
top.
2. Locate and mark the holes where belt and disc
sander is to be mounted.
3. Drill (2) x 9.5 mm diameter holes though
workbench.
4. Place belt and disc Sander on workbench aligning
holes drilled in workbench.
5. Insert two M8 screws and tighten hex nuts.
FIG. 13
SM 2610957110 05-08 6/5/08 7:36 AM Page 13