Filter
Top Products
14.
Operation
Turning on and off (Fig. 14)
1. To turn the sander ON, push the switch (1) to the
right (ON) position.
2. To turn the sander OFF, push the switch to the left
(OFF) position.
3. To lock the switch in the OFF position:
a. Wait until the sander has come to a complete
stop.
b. Remove the safety key
(2) from the switch
housing. Store the safety key in a safe place.
4. To unlock the switch and turn the sander ON, insert
the safety key into the switch, and move the switch to
the ON position.
Bevel sanding (Fig. 15)
1. The work table (3) can be tilted from 0° to 45° for
bevel sanding.
2. Loosen the table lock knob
(4) and tilt the work
table to the desired angle.
3. Retighten the table lock knob.
To avoid trapping the work or
fingers between the table and
sanding surface, the table should be repositioned
on the table support to retain a maximum of 1-2
mm distance between sanding surface and table.
Positioning belt bed (Fig. 16)
The belt bed locking hex screw (5) locks the belt bed
(6) in a vertical or horizontal position.
To adjust vertical position:
1.
Remove work support.
2. Loosen the hex head locking screw (5) using a 6
mm hex wrench.
3. Position belt bed and retighten the hex head
locking screw.
FIG. 14
FIG. 15
FIG. 16
1
2
3
5
4
WARNING
!
SM 2610957110 05-08 6/5/08 7:36 AM Page 14