Sony XDP-MU110 Work Light User Manual


 
19
Maintenance
Replacing the lithium battery of the
remote commander
When the battery becomes weak, the range
of the remote commander becomes shorter.
Replace the battery with a new CR2025
lithium battery. Use of any other battery
may present a risk of fire or explosion.
RM-X251
Notes on the lithium battery
Keep the lithium battery out of the reach of
children. Should the battery be swallowed,
immediately consult a doctor.
Wipe the battery with a dry cloth to assure a
good contact.
Be sure to observe the correct polarity when
installing the battery.
Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Cleaning the cradle
Clean the suction cup with the supplied
cleaning sponge, in order to maintain adhesive
strength.
Do not use alcohol, thinner or benzene to clean
the cradle, as the cradle may be damaged.
Do not use liquid detergent to clean the cradle.
Do not use a specialized cleaning cloth. Doing
so may cause discoloration.
Do not spray the cradle with a volatile
substance, such as an insecticide or a hair spray.
Doing so may cause deterioration of the cradle.
Do not place the cradle with a rubber, vinyl
product or repellent close together. Doing so
might be deteriorated the cradle.
Specifications
DSP Master Unit
AUDIO POWER SPECIFICATIONS
CEA2006 Standard
Power Output: 17 Watts RMS 4 at
4 Ohms < 1% THD+N
SN Ratio: 80 dBA
(reference: 1 Watt into 4 Ohms)
Power-AMP
Output: Speaker outputs 4 CH
(Front L/R, Rear L/R)
Speaker impedance: 4 Ω – 8 Ω
Maximum power output: 45 W × 4 (at 4 Ω)
General
Outputs:
Audio output terminals: (Front/Rear)
Subwoofer output terminal (mono)
Power amplifier control terminal
Inputs:
iPod signal input terminal (dock connector)
Hi-level input terminal
Sound controls:
Bass/Treble ±7 dB
Fader/Balance ±7 steps
SUB-W Volume* +/- 6Step , No sound
Power requirements: 12 V DC car battery
(negative ground (earth))
Dimensions: (Mounting dimensions)
Approx. 210.6 mm × 40 mm × 156.6 mm
(8
3
/
8
in × 1
5
/
8
in × 6
1
/
4
in) (w/h/d)
Mass: Approx. 0.92 kg (2 lb 1 oz)
Supplied accessories:
Card remote commander: RM-X251
Parts for installation and connections (1set)
* This function only works when a subwoofer is
connected to the system and the SUBWOOFER
switch on the DSP master unit is set to “Y.”
Cradle
Dimensions:
Approx. 65 mm × 138.8* mm × 105.3 mm
(2
5
/
8
in × 5
1
/
2
in × 4
1
/
4
in) (w/h/d)
Mass: Approx. 0.14 kg (5 oz)
* Arm fully extended: 147.1 mm (5
7
/
8
in) (h)
Your dealer may not handle some of the above
listed accessories. Please ask the dealer for
detailed information.
Design and specifications are subject to change
without notice.
1
2
c
+ side up
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose
of in fire.