Southbend SB1017 Saw User Manual


  Open as PDF
of 56
 
-12-
For Machines Mfg. Since 8/09
Model SB1017
PREPARATION
Inventory
The items listed below are optional components
and are not required for bandsaw operations.
Their installation and use is covered in
Operation, beginning on Page 19. Parts A and
D are required for Vertical Cutting (Page 30).
Description Qty
M. Table (Vertical Operation) .............................1
N. Work Stop .......................................................1
O. Work Stop Rod ...............................................1
P. Table Support (Vertical Operation) ..............1
Figure 6. Optional components.
O
N
P
M
Figure 5. Stand components.
K
J
L
I
Description (Figure 5) Qty
I. Rear Panel ......................................................1
J. Right Side Panel ............................................1
K. Front Panel .....................................................1
L. Left Side Panel ...............................................1
Description (Figure 4) Qty
A. Handle ............................................................1
B. Axle .................................................................1
C. Wheels ............................................................2
D. Leveling Feet ..................................................2
E. Handwheel .....................................................1
F Handwheel Handle ........................................1
G. Pulley Cover ...................................................1
H. V-Belt ..............................................................1
Figure 4. Small components.
C
D
E
B
A
F
G
H
Hardware (Not Shown) Qty
• Hex Nut
1
⁄4"-20 (Vertical Operation) .............1
• Flat Head Screw
1
⁄4"-20 x
1
⁄2"
(Vertical Operation) .......................................1
• Hex Wrench 4mm ..........................................1
• HexBoltM8-1.25 x 15 .................................21
• HexNutM8-1.25 ..........................................19
• Flat Washer 8mm ........................................40
• HexBoltM12-1.75 x 25 ................................4
• Flat Washer 12mm ........................................5
• KnobM6-1x15 ..............................................1
• CotterPins .....................................................2
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
 previous next