Southbend SB1017 Saw User Manual


  Open as PDF
of 56
 
For Machines Mfg. Since 8/09 Model SB1017
-31-
OPERATION
7. Place a level on the table, as shown in
Figure 44, then use the vertical stop bolt
shown in Figure 45 along with the slotted
table mount bracket to level the table.
Figure 44. Leveling vertical setup.
Figure 45. Vertical stop bolt (blade cover removed for
clarity).
Vertical
Stop Bolt
Operation Tips
The following tips will help you safely and
effectively operate your bandsaw and help you
get the maximum life out of your saw blades.
Horizontal Cutting
• Usetheworkstoptoquicklyandaccurately
cut multiple pieces of stock to the same
length.
• Clampthematerialrmlyinthevisejawsto
ensure a straight cut through the material.
• Letthebladereachfullspeedbefore
engaging the workpiece. Never start a cut
with the blade in contact with the workpiece.
• Payattentiontothechipsproducedbythe
cutting operation and use their appearance
to fine-tune the blade speed, feed speed,
and pressure (refer to the Chip Inspection
Chart on Page 27).
• Waituntilthebladehascompletelystopped
before removing the workpiece from the vise,
and avoid touching the cut end—it could be
very hot!
Vertical Cutting
• Donotcutworkpiecesthatcannotbe
properly supported or stabilized without
a vise in the vertical position. Examples
are chains, cables, round or oblong-shaped
workpieces, workpieces with internal or
built-in moving or rotating parts, etc.
• Makesurethattheverticaltableassemblyis
securely fastened to the bandsaw frame so it
will adequately support the workpiece.
• Adjuststheguidepostsotheopening
between the two blade guides is
approximately
1
⁄4" larger than the width of
the workpiece.
Release blade tension at the end of each use
to prolong blade life.
 previous next