Filter
Top Products
For Machines Mfg. Since 8/09 Model SB1021/SB1022
-33-
MAINTENANCE
If the table becomes difficult to tilt, position
it so that you can brush a thin coat of multi-
purpose grease on the trunnion sliding surfaces
(see Figure 36), then move back-and-forth to
distribute.
Lubrication
The bearings on your bandsaw are factory
lubricated and sealed. Leave them alone unless
they need to be replaced.
When needed, brush a light coat of multi-purpose
grease on the blade tension leadscrew (Figure
34).
Use multi-purpose grease and a light machine oil
where in Figure 35.
Figure 35. System lubrication points.
Grease
Fitting
Oil
Grease
Grease
Fitting
Behind
Plate
Oil
!
Figure 34. Upper wheel leadscrew lubrication.
Grease
!
The sliding surfaces on the guide post may
occasionally need to be lubricated with a light
machine oil if the movement becomes stiff.
Figure 37. Guide post lubrication.
Oil
!
Figure 36. Trunnion lubrication.
Trunnion Sliding
Surfaces
!