Filter
Top Products
20
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
16
Pump oil is low
compressor oil to pump. See Compressor Pump
Oil under Maintenance.
Carbon build-up in pump. Contact an authorized service center.
18
Detergent type oil being
used in pump
non-detergent, premium air compressor oil.
Motor overload protection
switch has tripped
See Motor Overload under Features.
20
length or gauge
Check for proper gauge wire and cord length.
See Extension Cords under Installation.
21
Loose electrical
connections
Contact an authorized service center.
22
Possible defective motor or
starting capacitor
Contact an authorized service center.
23
Paint spray on internal
motor parts
Contact an authorized service center. Do not
operate the compressor in the paint spray area.
See flammable vapor warning.
24
Fuse blown, circuit breaker
tripped
1. Check fuse box for blown fuse and replace
as necessary. Reset circuit breaker. Do not
use a fuse or circuit breaker with higher
rating than that specified for your particular
branch circuit.
fuse.
3. Check for low voltage conditions and/or
proper extension cord.
4. Disconnect the other electrical appliances
from circuit or operate the compressor on
its own branch circuit.
25
Tank pressure exceeds
pressure switch cut-in
pressure
Motor will start automatically when tank
pressure drops below cut-in pressure of
pressure switch.
26
Pressure release valve on
pressure switch has not
unloaded head pressure
Set the On/Off switch to OFF. If the valve does
not open, replace switch. Contact an authorized
service center.