Bostitch BTFP02028 Air Compressor User Manual


  Open as PDF
of 52
 
14 15
FIG. 4
WARNING HOT SURFACES
ADVERTENCIA
SUPERFICIES CALIENTES
AVERTISSEMENT
SURFACES CHAUDES
DO NOT ADJUST FACTORY SETTINGS.
TO REDUCE RISK OF ELE CTRIC SHOCK
DO NOT REMOVE COVER.
Pressure controls set at fact ory for
maximum sa fe operation.
NO HAGA CAMBIOS EN LOS AJUSTES
DE FÁBRICA. NO RETIRE LA TAPA PARA
REDUCIR EL RIESGO DE CHOQUE ELÉ C TRICO.
Los controles de presión se ajustan en la
fábrica para máxima segu ridad en la operación.
ADVERTENCIA
WARNING
AVERTISSEMENT
GLOSSARY
CFM:
Cubic feet per minute.
SCFM:
Standard cubic feet per minute; a unit of measure of air delivery.
PSI:
Pounds per square inch; a unit of measure of pressure.
KPA (KILOPASCAL):
Metricpressuremeasurement.1kilopascalequal1000pascals.
CODE CERTIFICATION:
Productsthatbearoneormoreofthefollowingmarks:UL®,CUL,CULUS,
ETL®,CETL,CETLUS,havebeenevaluatedbyOSHA certified independent safety laboratories
and meet the applicable Standards for Safety.
*UL®isaregisteredtrademarkofUnderwritersLaboratoriesandETL®isaregistered
trademarkofElectricalTestingLaboratories.
CUT-IN PRESSURE:
While the motor is off, air tank pressure drops when accessory is used.
When the tank pressure drops to a certain low level the motor will restart automatically. The
low pressure at which the motor automatically restarts is called cut-in pressure.
CUT-OUT PRESSURE:
When an air compressor is turned on and begins to run, air pressure in
the air tank begins to build. It builds to a certain high pressure before the motor automatically
shuts off, protecting your air tank from pressure higher than its capacity. The high pressure at
which the motor shuts off is called cut-out pressure.
BRANCH CIRCUIT:
The circuit carrying electricity from electrical panel to outlet.
DUTY CYCLE:
For proper operation of your air compressor, it is recommended that a 50% duty
cycle be maintained; that is, the air compressor should not run more that 5 minutes in any 10
minute period.
TROUBLESHOOTING GUIDE
This section provides a list of the more frequently encountered malfunctions, their causes
and corrective actions. The operator or maintenance personnel can perform some corrective
actions, and others may require the assistance of a qualified BOSTITCH technician or your
dealer
Problem Code
Excessiveairtankpressure-safetyvalvepopsoff............................................................................1,2
Air leaks ............................................................................................................................................................3
Air leaks in air tank or at air tank welds ..................................................................................................4
Air leaks between head and valve plate .................................................................................................5
Air leaks from safety valve...........................................................................................................................6
Knocking Noise .............................................................................................................................................6
Pressurereadingontheregulatedpressuregaugedropswhenanaccessoryisused............7
Compressorisnotsupplyingenoughairtooperateaccessories.......................8,9,10,11,12,22
Regulator knob has continuous air leak.................................................................................................13
Regulator will not shut off air outlet........................................................................................................13
Motorwillnotrun...............................................................................................6,14,15,16,17,18,19,20
Squealing Sound...........................................................................................................................................21
 previous next