Filter
Top Products
© 1995 Wagner Spray Tech 3 All rights reserved.
SAFETY PRECAUTIONS
This manual contains information which must be read
and understood before using the equipment. When you
come to an area which has one of the following symbols,
pay particular attention and make certain to heed the
safeguard.
WARNING
This symbol indicates a potential hazard which may
cause serious injury or loss of life. Important safety
information will follow.
CAUTION
This symbol indicates a potential hazard to you or to the
equipment. Important information that tells how to
prevent damage to the equipment or how to avoid causes
of minor injuries will follow
NOTE: Notes give important information which
should be given special attention.
CAUTION
THIS UNIT IS PROVIDED WITH A THERMALLY PRO-
TECTED AUTOMATIC RESET. IF AN OVERLOAD
OCCURS THE THERMALLY PROTECTED AUTO-
MATIC RESET DISCONNECTS THE MOTOR FROM
THE POWER SUPPLY.
• The motor will restart without warning when the
protector automatically resets.
• Always disconnect the motor from the power supply
before working on the equipment.
• When the thermally protected automatic reset discon-
nects the motor from the power supply, relieve pres-
sure by turning the priming valve to PRIME ( ).
• Turn the ON/OFF switch to OFF.
NOTE: The cause of the overload should be cor-
rected before restarting. See TROUBLE-
SHOOTING.
WARNING
INJECTION INJURY - A high pressure stream of
paint produced by this equipment can pierce the skin
and underlying tissues, leading to serious injury and
possible amputation.
DO NOT TREAT AN INJECTION INJURY AS A SIMPLE
CUT! Injection can lead to amputation. See a physician
immediately.
NOTE TO PHYSICIAN:
Injection into the skin is a traumatic injury. It is important
to treat the injury surgically as soon as possible. DO NOT
delay treatment to research toxicity. Toxicity is a concern
with some coatings injected directly into the blood stream.
Consultation with a plastic surgeon or reconstructive
hand surgeon may be advisable.
• The maximum operating range of the gun is 2500 PSI
fluid pressure.
• NEVER aim the gun at any part of the body.
• NEVER allow any part of the body to come in contact
with the fluid stream. DO NOT come in contact with a
fluid stream created by a leak in the fluid hose.
• NEVER put your hand in front of the gun. Gloves will
not provide protection against an injection injury.
• ALWAYS lock the gun trigger, shut the fluid pump off
and release all pressure before servicing, cleaning the
tip guard, changing tips, or leaving unattended. Pres-
sure will not be released by turning off the engine. The
PRIME/SPRAY knob must be turned to PRIME ( ) to
relieve the pressure. Refer to the PRESSURE RE-
LIEF PROCEDURE described in this manual.
• ALWAYS have the tip guard in place while spraying.
The tip guard provides some protection against
injection injuries but is mainly a warning device.
• ALWAYS remove the spray tip before flushing or
cleaning the system.
• The paint hose can develop leaks from wear, kinking
and abuse. A leak is capable of injecting material into
the skin. Inspect the paint hose before each use.
• NEVER use a spray gun which does not have a trigger
lock or trigger guard in place and in working order.
• All accessories must be rated at or above 2500 PSI.
This includes spray tips, guns, extensions, and hose.
• DO NOT TREAT AN INJECTION INJURY AS A
SIMPLE CUT! A skin injection can lead to amputation.
See a physician immediately.