Filter
Top Products
© 1995 Wagner Spray Tech 7 All rights reserved.
PRESSURE RELIEF PROCE-
DURE
Follow this procedure after the unit is assembled and
before any operation which involves the spray gun such
as cleaning and maintenance or changing tips or acces-
sories.
1. Turn the pressure control knob counterclockwise to
its lowest setting.
2. Turn the PRIME/SPRAY knob to PRIME ( ).
3. Trigger the gun to remove any pressure which may
still be in the hose.
4. Lock the gun by turning the gun safety switch so
that it is parallel to the gun body.
WARNING
Injection hazard. Do not spray without the tip guard
in place. NEVER trigger the gun unless the tip is
completely turned to either the spray or the unclog
position. ALWAYS engage the gun safety switch
before removing, replacing or cleaning tip.
Attaching the paint hose
1. Attach the high pressure hose to the paint hose port.
Use an adjustable wrench to tighten the paint hose
securely.
2. Attach the gun to the other end of the high pressure
hose. Tighten securely with two adjustable
wrenches.
3. Plug the Wagner 830 into a properly grounded outlet
or heavy duty grounded extension cord. Do not use
more than 100 feet of cord. If you must spray a long
distance from a power source, use more paint hose,
not more extension cords. Use a minimum size of
16 gauge for power extension cords up to 50 feet in
length, or 12 to 14 gauge for power extension cords
between 50 and 100 feet in length.