Filter
Top Products
7
FinishControl 5000
AUS
13 MAINTENANCE
13.1 AIR FILTER
Attention! Never operate the device with
the air lter soiled or missing, as dirt could
be sucked up and aect the operation of
the device.
Always check the air lter before starting
work.
1. Unplug the power plug.
2. Open the cover of the air lter compartment (Fig. 21).
3.
Clean (blow out) or replace the air filter (Fig. 21,1)
depending on the degree of soiling.
13.2 AIR RELIEF VALVE
If paint has entered the ventilation hose, proceed
as follows:
1. Pull the ventilating hose (Fig. 22, 1) at the top from the
gun body. Screw o the valve cover (2). Remove the
diaphragm (3). Clean all the parts carefully.
CAUTION! The ventilation hose and
diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent,
only wipe.
2. Place the diaphragm in the valve cover with the pin facing
forward (Also see the marking on the gun body).
3. Turn the body of the gun upside down and screw on the
valve cover from underneath.
4.
Place the ventilating hose on the valve cover and on the
nipple at the gun body.
MAINTENANCE