Filter
Top Products
2
FinishControl 5000
AUS
5. Service
a) Have your tool repaired only by qualied specialist
personnel and only with original spare parts. This
ensures that the tool safety is maintained.
b) If the supply cord is damaged, it must be replaced
by the manufacturer or it’s service agent or a
similarly qualied person in order to avoid a safety
hazard.
Safety instructions for colour application
devices
1. Risks of Fire and Explosion
Combustible gases develop in the work area
when spraying coating substances and due to the
autonomous formation of coating substances and
solvent vapors (danger zone).
Risk of re and explosion due to ignition sources in
this danger zone.
The electrically operated spray device contains
potential ignition sources (spark formation when
switching the motor on and o, when inserting and
removing the power plug, due to potential static
electricity at the spray gun)
-> Device must not be used at operating sites that fall
under the explosion protection ordinance.
-> Basic unit and mains connection must be located
outside the danger zone.
-> Do not use combustible coating substances and
cleaning agents -> observe product data sheets!
->Always seal paint or solvent containers tightly in
the vicinity of the device.
-> No ignition sources such as open re, lit tobacco
products, glowing wires, hot surfaces, sparks e.g. due
to angle grinders etc. must be present.
-> When cleaning the device with solvent do not spray
into a container with a small opening (bung hole).
Danger due to formation of an explosive gas/air
mixture.
The container into which you are spraying must be
earthed.
2. Warning: Danger of injury!
Never point spray gun at yourself, other persons or
animals.
3.
Wear breathing equipment when spraying.
The user should be supplied with a breathing mask. In order
to avoid occupational diseases, the working instructions
SAFETY REGULATIONS
provided by the manufacturer of the materials, solvents
and cleaning agents used must be complied with during
preparation, working with and cleaning the equipment.
Protective clothing, gloves and, if necessary, protective skin
cream is required to protect the skin.
4.
Warning: When working with the paint spraying
system, both indoors and outdoors, care should
be taken that no solvent vapours are driven to the
motor-operated blower or that no solvent containing
vapours form in the area around the paint spraying
system. Place the motor-operated blower on the
opposite side to the object to be sprayed. When
working outdoors take wind direction into account.
When working in closed places a sucient ventilation
must be ensured to remove the solvent vapours. The
distance from the motor – operated blower to the
object to be sprayed must be at least 3 m.
5. Warning: The device is not splash proof. It should not
be used, neither outdoors in the rain nor be sprayed
with water nor immersed in liquid. Do not use the
device in damp or wet environments.
6. The units may only be used with a functional valve. If
paints rises in the ventilating hose (Fig. 1, item 17) do
not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the
diaphragm if necessary.
7. Do not lay the lled spray gun down.
8. Extraction systems should be installed on-site according to
the local regulations.
9. The object to be coated must be earthed.
10. Caution against dangers that can arise from the sprayed
substance and observe the text and information on the
containers or the specications given by the substance
manufacturer.
11. Do not spray any liquid of unknown hazard potential.
12. Before dismounting the spray attachment, relieve
pressure by opening the container.
13. Before working on the device, remove the power plug
from the socket.
14. Work or repairs on the electrical equipment should only
be carried out by a professional electrician, even if there
are instructions regarding such work in the operating
instructions. No liability will be accepted for improper
installation.
15. Do not sit or stand on the device. Danger of tilting/
breaking!