Wagner SprayTech 276040 Paint Sprayer User Manual


  Open as PDF
of 16
 
Maintenance
Use the following procedures to keep your HVLP spray system
running properly.
Cleaning/Replacing the Filters
1. Remove each lter by grabbing them and pulling them
straight out of the lter cans on the turbine. This will not
damage the lters.
Cooling Air Filter
Two-Stage Atomizing
Air Filter
(green side facing
the turbine)
2. Clean the lters. Either tap the lters to knock out the
contaminants or use pressurized air to blow out the
contaminants. For material that is not blown or knocked
loose easily, soak the lters in soapy water or mineral
spirits. Allow the lters to dry completely before placing
them back in the turbine.
NOTE: Donotusehighlyammablesolvents,suchas
lacquerthinner,tocleanthelters.
3. Insert each lter back into its corresponding lter can.
NOTE: Thetwo-stage,atomizingairltermustbeplaced
intheltercanlabeled“2-StageFilter”withthe
green side facing the turbine.
After several cleanings, it may become necessary to replace the
lters. Refer to the parts list near the end of this manual for the
lter replacement kit part number.
Cleaning the Air Hoses
1. Periodically wipe the outer surface of the air hose with a
damp cloth to keep clean.
IMPORTANT: DO NOT submerge into or flush the air hose
with water or any chemical.
IMPORTANT: DO NOT use methylethylketon (MEK),
naphtha, mineral spirits, paint thinner, xylol/xylene, or toluel/
toluene to clean the air hose. Exposure over time could
cause damage to the hose.
4 © SprayTECH. All rights reserved.
English
CS9900 Wiring Diagram
Circuit breaker
P/N 0295960
ON / OFF switch
P/N 9850936
Warning light assembly
P/N 0277193
Ground (bolts to turbine housing)
Green
wire
White wire
Black wire
Power cord
P/N 0524328
Air flow switch
P/N 0277472
1
2
4
5
Turbine
P/N 0277986
Uncontrolled Copy
 previous next