Filter
Top Products
Setup
Attaching the Handle
1. Slide the handle into the stand until the holes on the
handle line up with the holes in the stand.
2. Slide the handle pins through the holes in the stand and
the handle to secure the handle in position.
Attaching the Paint Hose
1. Attach the high pressure hose to the paint hose port. Use
a wrench to tighten the paint hose securely.
2. Attach the gun to the other end of the high pressure hose.
Tighten securely with two wrenches.
3. Plug the sprayer into a properly grounded outlet or heavy
duty grounded extension cord. Do not use more than 100
feet of cord. If you must spray a long distance from a
power source, use more paint hose, not more extension
cords. Use a minimum size of 16 gauge for power
extension cords up to 50 feet in length, or 12 to 14 gauge
for power extension cords between 50 and 100 feet in
length.
SPRAY
PRIME
High Pressure Hose
SPRAY
NOTE: The sprayer should remain unplugged during
assembly.
Attaching the Tip
Assembling the Tip
If the spray tip is disassembled:
1. Insert the tip into the spray guard and turn the tip to the
spray position so that the arrow is facing toward the front
of the spray gun.
Attaching the Tip to the Gun
1. Lock the gun by turning the gun trigger lock so that it is
parallel to the gun body.
POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is in
either the spray or the unclog position. Always engage the
gun trigger lock before removing, replacing, or cleaning tip.
2. Thread the spray tip onto the gun. Tighten the nut by
hand first, then tighten more firmly with a wrench.
Begin
tightening
the tip at
this angle
to achieve
the desired
spray angle
when tight.
NOTE: When attaching the tip to the gun, align the
tip guard as shown in the figure below, then
tighten with a wrench.
WARNING
Gun locked OFF
(gun will not spray)
Spray Guard
Tip
© SprayTECH Corporation. All rights reserved. 5
English