Filter
Top Products
GB
22
W 687 E
b) For interior wall paint
i
Spray material that is at least at room temperature (e.g. diluted with warm
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet Download).
Stir the material thoroughly and dilute it in the container as per the recommended
1.
dilution (an agitator is recommended for stirring).
Thinning recommendation
Sprayed material
Interior wall paint (dispersions and latex paint) dilute by 10 %
If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until 2.
the feed rate meets your requirements.
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
Attach the carrying strap to the unit. (Fig. 2)1.
Unscrew the container from the spray gun. 2.
Aligning suction tube. (Fig. 3)
3.
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
i
For easier coating of ceilings and lying objects, we recommend the 60 cm
HVLP handle extension. (Order no. 2307 678)
Set the container on a sheet of paper, pour in the prepared coating material and screw
4.
the container tightly onto the spray gun.
Connect the front part with the rear part of the gun. (Fig. 5)5.
Mount the air hose (Fig. 4, a + b). Insert the air hose rmly into the connection of the 6.
unit and the gun handle. The position of the hose is not relevant.
Sling on the carrying strap with the unit.7.
Press the ON/OFF switch at the device.8.