Filter
Top Products
4
PRESSURE REGULATOR ADJUSTMENT
These controls are shipped from the factory with the regulator
set as specified on the control label. Consult the appliance rat-
ing plate to ensure burner manifold pressure is as specified. If
another outlet pressure is required, follow these steps.
INSTALLATION
Natural Gas: Two-Stage Models - Low outlet pressure will
be factory-adjusted in the 1 to 3.5” W.C. range and high outlet
pressure will be factory-adjusted in the 2.5 to 5” range. The
valve cannot be adjusted outside this range and the high outlet
pressure setting must always be set at least 1.5” above the low
outlet pressure setting.
Single Stage Models- Outlet pressure will be factory-adjusted
in the 2.5” to 5” range. The valve cannot be adjusted outside
this range.
LP Gas: Two-Stage Models - Low outlet pressure will factory-
adjusted in the 4” to 9.5” W.C. range and high outlet pressure
will be adjusted in the 8 to 12” W.C. range. The valve cannot
be adjusted outside this range and the high outlet pressure
setting must always be set at least 2.5” above the low outlet
pressure setting.
Single Stage Models - Outlet pressure will be factory-adjusted
in the 7 to 12” range. The valve cannot be adjusted outside this
range.
WIRING DIAGRAM - HSI MODELS
36H2X & 36H5X
WIRING DIAGRAM -
PILOTED MODELS
36H3X & 36H6X
Redundant
Coil
(+)
(-)
SW1
SW1
SW2
P
C
Main
Coil
(+)
(-)
M
SW2
Two-Stage
Coil
(+)
(-)
RECTIFIER
Rectifier
Rectifier
HI
Two Stage Models Only
WIRING DIAGRAM - Piloted MODELS
Rectifier
SW1
SW1
SW2
SW2
(+)
(-)
PM
C
HI
Main
Coil
Redundant
Coil
Two-stage
Coil
Two Stage Models Only
WIRING DIAGRAM - HSI MODELS
Figure 4. System Wiring
ADJUSTMENT
SYSTEM WIRING
REFER TO AND FOLLOW THE APPLIANCE MANU-
FACTURER’S WIRING DIAGRAM. REFER TO FIG. 4
FOR TERMINAL IDENTIFICATION.
All wiring should be installed in accordance with local and na-
tional electrical codes and ordinances.
Always check that the electrical power supply used agrees with
the voltage and frequency shown on the gas control.
NOTE
NOTE