Filter
Top Products
7
Introduction
This manual includes operating and maintenance
instructions for the Wilton Model 4210 Belt and Disc
Sander. This manual also includes parts listings and
illustrations of replaceable parts.
Belt and Disc Sander
Features
Figures 1 and 2 depict the main features of the
Wilton Model 4210 Belt and Disc Sander. (Specifica-
tions for the sanding machine are provided on page
3.)
Figure 1: Belt and Disc Sander Features
(Right Side View)
Figure 2: Belt and Disc Sander Features
(Left Side View)
The sander has both a sanding belt and a sanding
disc for use on a variety of work pieces and materi-
als.
The platen housing for the belt sander can be posi-
tioned vertically or horizontally. When in the vertical
position, the drum at the upper end of the platen
housing can be used for contouring. A tracking
adjustment mechanism for the sanding belt is pro-
vided at the upper end of the platen housing.
The platen housing has a lever that is used to apply
tension to the sanding belt. The sanding belt is easily
replaced by releasing the tension lever, removing a
sanding shroud and dust collection duct at the bottom
of the platen housing, and slipping the belt from the
belt sander drums. Installation is the reverse of the
removal steps.
Tracking Adjustment
Belt Tensioning Lever
Belt Work Table
Clamping Knob
Sanding Disk
Miter Gauge
Disc Work Table
Clamping Knob
Disc
Debris
Duct
Sanding Belt
Belt Guard
Platen Housing
Debris Duct
On/Off
Switch
Power Cord
Stand
Machine
Base
Belt Sander
Work Table