Filter
Top Products
Drip Shield Installation (For Marine Installations)
975-0395-01-01 1–31
This guide for use by qualified installers only
Drip Shield Installation (For Marine Installations)
The drip shield helps to protect the unit from dripping or splashing
liquids, which will cause a shock hazard. Drip shields are especially
useful in marine installations where water from condensation, rain, or sea
may come into contact with the Freedom HF.
You may purchase the drip shield set by contacting Xantrex. When
ordering, mention part number 808-9531.
To install the drip shields:
1. Gather the four screws needed to fasten a single drip shield to a wall.
2. Locate an appropriate setting for the drip shields above the Freedom
HF making sure you cover the entire width of the unit.
You can overlay the shields as shown in Figure 1-11 below.
WARNING: Shock hazard
This product is intended only for use in dry areas. Operating the unit under wet
conditions may expose you to a shock hazard. Installing drip shields may not
entirely protect you from this hazard. Do not operate the unit when it is wet.
Figure 1-10
Drip Shields
Drip Shield set part# 808-9531
Different Views)
FreedomHF_IC_01-Installation.fm Page 31 Monday, December 24, 2007 9:47 AM