Xantrex Technology Link 2000 Battery Charger User Manual


 
2
TABLE OF CONTENTS
One Page Summary of Features Center
Introduction and Special Notes 3
Monitor Functions 4–5
Inverter and Charger Functions 5
Status Line and Starting and Stopping Equalize 6
Setup 7
Inverter Setup 8
Monitor Setup 9
Functions Setup 10–14
Data Mode 15
How to Use The Link 2000 Control Panel 16–17
Ideal Charge Curve 18
Synchronizing to a Full Battery (Resetting Amp Hours to Zero) 20
Rules for Changing the Charged Parameters 21
Selection Rules 22
Reset / Info Functions 23
High Discharge Rates and Peukert's Equation 24–25
Typical Peukert's Exponents 26–27
Error Codes and Troubleshooting 28–29
Microprocessor Reset Procedure (Resetting to Factor Defaults) 30–31
Setup and Historical Data Summary 32
Warranty 33
Required Reading Prior to Installation 36
Wire By Wire Instructions 37
Specifications 39
INSTALLERS: THIS DOCUMENT IS IMPORTANT FOR
OPERATION—PLEASE LEAVE IT WITH THE OWNER.
THIS MANUAL APPLIES TO LINK 2000 METERS WITH SERIAL NUMBERS ABOVE 8500
AND LINK 2000-R METERS WITH SERIAL NUMBER ABOVE 5000
Notice of Copyright
Xantrex Link 2000 Inverter Controller and Dual Battery Monitor © October 2002 Xantrex
International. All rights reserved.
Disclaimer
UNLESS SPECIFICALLY AGREED TO IN WRITING, XANTREX TECHNOLOGY INC.
(“XANTREX”)
(a) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR SUITABILITY OF
ANY TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER
DOCUMENTATION.
(b) ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSS OR DAMAGE, WHETHER
DIRECT, INDIRECT, CONSEQUENTIAL OR INCIDENTAL, WHICH MIGHT ARISE OUT OF
THE USE OF SUCH INFORMATION. THE USE OF ANY SUCH INFORMATION WILL BE
ENTIRELY AT THE USER’S RISK.
Date and Revision: October 2002, Revision 1 Part Number: 445-0198-01-01
Contact Information Web: www.xantrex.com Email: CustomerService@xantrex.com
Phone: 1 800 670 0707 (toll free in North America) 1 604 422-2777 (direct) Fax: 1 604 420-2145